Mini Control Panel

Home
What's New
Requirements
Installation
ShowCAD USB
Pathport
Artnet
Basic USB
Digital and Analog
Edirol PCR
Mini Control Panel
Backup / Restore
Registration
Artist Remote
DirectX
Beta Version
Web Control

These panels can be supplied in a standard wall mounted electrical box. Physical installation is outlined here. To understand how to set up the software refer to the Artist Help.

The panel is supplied with a 5Volt DC power supply which is connected to the panel via the terminal block. It interfaces to a computer via the COM ports (RS232). You can add as many panels as you have free COM ports.

Great care must be taken in making this connection as reversing the polarity of the power supply will result in damage to the control panel electronics.

1) +5 volts	connects to the wire marked +5 from the provided power supply.
2) RS232 RX	connects to the TX signal from the computer serial port. This is pin 3 on the 9 pin D connector on the computer serial port.
3) RS232 TX	connects to the RX signal from the computer serial port. This is pin 2 on the 9 pin D connector on the computer serial port.
4) RS232 Common	This is the serial common and is pin 5 on the computer serial port.
5) 0 volts	connects to the wire marked 0v from the provided power supply.